40 Gallon Breeder Aquarium dimensions
A standard 40 gallon aquarium is 36 in long, 18 in wide and 16 in tall. Rated sizes are brim-full nominal; real water volume is lower after substrate and the air gap — read the chart at your actual water line.
Measurements differ from the standard ones below? The rectangular tank volume calculator works out gallons at any fill depth for your own tank.
| Spec | Value |
|---|---|
| Length | 36 in |
| Width | 18 in |
| Height | 16 in |
| Geometric capacity | 44.9 gal |
| Nominal rating | 40 gal |
| Liquid weight (brim-full) | 375 lb of water |
| Empty tank weight | Varies by gauge/manufacturer — see nameplate or spec sheet |
Nominal rating versus real geometry
Rated 40 gal. Computed from the dimensions in the table above: 44.9 gal. The shell is built oversize by 4.9 gallons — 12.2 % — against its label. Aquarium sizes are rounded trade labels, so the glass box can hold more than its name says.
What this weighs on your floor
| Water, brim full | 375 lb |
| Plus glass, substrate, rock and stand (≈ 25 % allowance) | ≈ 468 lb gross |
| Footprint | 36 in × 18 in = 4.5 ft² |
| Load over its own footprint | ≈ 104 lb/ft² |
| IRC design live load, habitable room (not a bedroom) | 40 lb/ft² |
| IRC design live load, sleeping room | 30 lb/ft² |
That is roughly 2.6× the 40 lb/ft² design live load in IRC Table R301.5, over the tank's own footprint — what that does and does not mean is set out in the aquarium reference.
What is the same for every tank of this kind (floor loading, from rated size to actual water volume, what governs an aquarium's rated size) is set out once on the sizes hub, in the aquarium reference and the common questions for every tank.
Dimension drawing
FAQ
What are the dimensions of a 40 gallon breeder aquarium?
As modelled on this page: length 36 in, width 18 in, height 16 in. Check your tank's nameplate or data sheet; a particular maker's tank can differ.
How much does a full 40 gallon breeder aquarium weigh?
About 375 lb of water when filled to the brim. Add the weight of the empty tank and everything in it for the total.
Sources and standards
- Handbook 44, Appendix C — General Tables of Units of MeasurementNational Institute of Standards and Technology, U.S. Department of Commercehttps://www.nist.gov/document/2026-nist-handbook-44-appendix-c
- International Residential Code, Table R301.5 — Minimum uniformly distributed live loadsInternational Code Council (free read-only access at codes.iccsafe.org)https://codes.iccsafe.org/s/IRC2021P2/chapter-3-building-planning/IRC2021P2-Pt03-Ch03-SecR301.5
- Methodology — the partial-fill formulas and liquid densities used on this sitetankvolumecalc.comhttps://tankvolumecalc.com/methodology/
- Special Publication 811, Appendix B.8 — Factors for Units Listed AlphabeticallyNational Institute of Standards and Technologyhttps://www.nist.gov/pml/special-publication-811/nist-guide-si-appendix-b-conversion-factors/nist-guide-si-appendix-b8
Every linked source above was retrieved and checked on 2026-09-02.